Advertisement
ATTACHING THE UNIT: SGL models
equipped with a direct coupling
system
Your Pro-Tech Sno Pusher® Loader Model
(SGL) is equipped with the manufacturer's OEM
Quick Coupler
1. Remove the bucket from your loader.
2. Drive machine into the coupler located on
the back of the Sno Pusher®.
3. Engage the locking pins.
NOTE: The coupler assembly may need
to be re-positioned to remain centered
and aligned with prime mover.
ATTACHING THE UNIT: SGM model
Your Pro-Tech Sno Pusher® Compact Wheel
Loader Model (SGM) is equipped with the
manufacturer's OEM Quick Coupler
1. Remove the bucket from your compact
wheel loader.
2. Drive machine into the adapter located
on the back of the Sno Pusher.
3. Engage the locking pins.
MAINTENANCE
Your Pro-Tech Sno Pusher® requires only
minimal service to remain in top condition. Follow
these simple guidelines to ensure proper plowing
and long life:
FUSION EDGE (Height Adjustment)
The height of Fusion Cutting Edge™ can be
adjusted without any tools.
Raise unit off the ground to access the rear of the
wear shoe. From the inside of the side plate
locate and remove the lynch pin. (Figure 4a)
Slightly raise the shoe upward to remove bearing
weight on the shoe pin. Remove shoe pin and
select desired adjustment position. Replace shoe
pin and lynch pin. Repeat on opposite side
maintaining the same hole height locations for
each. Optimum position should not expose more
than ½" of rubber edge.
Pro-Tech Manufacturing and Distribution, Inc.
711 West Ave ▪ Rochester, New York 14611
888-787-4766
www.snopusher.com
Figure 4a
Advertisement
