Advertisement
INSTALLING THE BINDER KIT
1. Grab hooks are to be welded to the side
or back corners of your machine's
bucket.
The location you choose MUST allow
chains to be positioned parallel to the
ground when attached. This will ensure
level operation of the Sno Pusher to your
machine.
2. Attach one section of transport chain to
the right side of the Sno Pusher using a
3/8" clevis. (Figure 3a)
Drop opposite end of this chain into grab
hook on the right side of the bucket. Leave
enough slack in the chain to allow centering
of the unit and coupler.
Figure 3a
Pro-Tech Manufacturing and Distribution, Inc.
711 West Ave ▪ Rochester, New York 14611
www.snopusher.com
3. Attach additional section of transport
chain to the left side of the Sno Pusher
using a 3/8" clevis.
Drop opposite end of this chain into grab
hook on the left side of the bucket. Leave
enough slack in the chain to attach the
ratchet binder and allow centering of the
unit. (Figure 3b)
4. Now that both chains are in place, you
need to ensure full range of motion of the
floating coupler while maintaining contact
between your bucket and the inside of
the post receptacles.
CAUTION: Do not use the lift hooks
located at the top and rear of the Sno
Pusher for chain attachment. These
hooks are designed for lifting the unit
only and not for plowing.
For SGL, Binder Kit Includes:
2 – 10' sections of 3/8" P-43 Transport Chain
2 – 5/16" Grab Hooks
1 – 3/8" Heavy Duty Ratchet Binder
2 – 3/8" Shackles
For SGM, Binder Kit Includes:
2 – 5' sections of 3/8" P-43 Transport Chain
2 – 5/16" Grab Hooks
1 – 3/8" Heavy Duty Ratchet Binder
2 – 3/8" Shackles
888-787-4766
Figure 3b
Advertisement
