Advertisement
FUSION EDGE™ BREAK-IN PROCEDURE
The Fusion Edge™ is a reversible cutting edge
and comes in sectional pieces that have steel
fully encapsulated in the rubber. (Figure 1a)
Figure 1a
Pro-Tech has designed the cutting edge by fully
encapsulating the steel in the rubber to protect it
from environmental elements before use. Prior to
plowing, the cutting edge can be broken in to
expose the steel component. (Figure 1b) This will
optimize the surface outcome
Figure 1b
If you choose to break-in prior to first use, this
can be accomplished by hooking up the pusher to
your prime mover and running it forward with
moderate down pressure on a hard, dry concrete
or asphalt surface for a minimum of 100 feet.
Check the edges to see if the steel edges have
been exposed and continue the break in process
as necessary. This procedure will need to be
repeated when replacing or reversing the cutting
edge.
ATTACHING THE UNIT: SGL and SGM
models equipped with post
configuration design
Attaching the Sno Pusher to your machine is
made easy with Pro-Tech's Quick Change™
Design.
Pro-Tech Manufacturing and Distribution, Inc.
711 West Ave ▪ Rochester, New York 14611
888-787-4766
www.snopusher.com
1. Drive the cutting edge of machine's
bucket into the post receptacle on the
back of the Sno Pusher. (Figure 2a and
2b)
Figure 2a
Figure 2b
The bucket will come to rest against the
steel bucket stops. The upper posts will
fit inside the bucket and should be
centered. The lower posts will be
positioned under the bucket.
2. Attach the chains and binders to secure
the Sno Pusher to your machine.
Advertisement
