Advertisement
Advertisement
Table of Contents
Related Manuals for Edco VORTEX-300
Summary of Contents for Edco VORTEX-300
- Page 1 E-VORTEX300-I-0110 Operator’s Instruction Manual VORTEX-300 Manual - Portable 100 Thomas Johnson Drive, Frederick, MD 21702-4600 USA Printed in USA Phone (301) 663-1600 • 1-800-638-3326 ©2010 Fax (301) 663-1607 • 1-800-447-3326 Page 1 Website: www.edcoinc.com Email: sales@edcoinc.com...
-
Page 2: Safety Instructions
E-VORTEX300-I-0110 READ AND UNDERSTAND THE OPERATORS INSTRUCTION MANUAL THOROUGHLY BEFORE ATTEMPTING TO OPERATE THIS EQUIPMENT. Death or serious injury could occur if this machine is used improperly. SAFETY • Do not disconnect power by pulling cord. To disconnect, grasp SAFETY MESSAGES the plug, not the cord. -
Page 3: Table Of Contents
Figure 1 HOW TO ORDER REPAIR PARTS VORTEX-300 To insure product safety and reliability, always use genuine EDCO replacement parts when making repairs to the equip- “A” 25” (63.5cm) ment. 59” (150cm) “B”... -
Page 4: Safety Guidelines
E-VORTEX300-I-0110 Read and understand this Operator’s Instruction Manual, and the Engine Manufacturer’s Owner’s Manual before operating this equipment. Death of serious injury can result if this machine is used improperly. Safety Guidelines Eye and ear protection must be worn at all times while the saw is in use. During normal operation, sound pressure levels exceed 85dBA. -
Page 5: Inspection And Maintenance
CAUTION: Clogged material should only be removed by hand. Using an instrument to dislodge material may tear the filter. Consult your EDCO representative if material blockage is excessive. 6. Inspect the pleats of the filter for tears and material blockage. - Page 6 E-VORTEX300-I-0110 HEPA Filter Removal and Installation NOTE: All HEPA filter machines are equipped with a differential pressure gage. The gage measures the pressure above against the pressure below the filter, thereby measuring the restriction of airflow due to contamination. HEPA filters should be replaced when the gage consistently measures 4 inches W.C. 1.
-
Page 7: Trouble Shooting
11. Secure the motor deck then turn the machine off. Turbine Maintenance Turbine maintenance should only be performed in an authorized shop as designated by EDCO due to the precision involved in balancing high rpm devices. This includes and is mainly specific to the replacement of bearing compo- nents. -
Page 8: Limited Equipment Warranty
*Seller reserves the right to alter payment terms. EDCO will, at its option, repair or replace, at the EDCO factory or at a point designated by EDCO, any part which shall appear to the satisfaction of EDCO inspection to have been 3.
Need help?
Do you have a question about the VORTEX-300 and is the answer not in the manual?
Questions and answers