Installation Of Indoor, Outdoor Unit - LG TB-H488RSS5 Service Manual

Installation of Indoor, Outdoor Unit

1. Selection of the best location
1) Indoor unit
Select location
Install the air conditioner in the location that satis-
fies the following conditions.
• Place should easily bear a load exceeding four
times the indoor unit's weight.
• The place should enable the unit to be inspected
as shown in fig.
• The place should be such that leveled.
• The place should allow easy water drainage.(Suit-
able dimension "H" is necessary to get a slope to
drain as figure.)
• The place should easily connect with the outdoor
unit.
• The place where the unit is not affected by an
electrical noise.
• The place where air circulation in the room will be
good .
• There should not be near the unit any heat source
or steam.
2) Outdoor unit
• If an awning is built over the unit to prevent direct
sunlight or rain exposure, be careful that heat
transfer from the condenser is not restricted.
• There should be no animals or plants in vicinity of
the hot discharged air.
• Ensure the space indicated by arrows from the
wall, ceiling, fence or other obstacles.
Top view
(unit: mm)
Front view
More than
30cm
F e
n c e
o b
s t a o r
c l e
s
–13–
Inspection hole
(450X450)
Control box
450
Front
H
More than
70cm
More than
30cm