Advertisement
To remove or replace digits:
1. REMOVE ALL POWER FROM THE SCOREBOARD.
2. Unscrew the (4) four screws that hold the digit in place and slowly pull the digit away from
scoreboard.
3. Detach the 9-pin segment data cable connector by pressing down on the top the latch on the side
of the locking connector and pulling up on the connector. The Digit is removed.
4. Take the new digit and connect the 9-pin connector in the scoreboard to the 9-pin connector on
back of digit. DO NOT FORCE.
NOTE: The connector is polarized and must be installed in only one direction.
5. Replacing the (4) four screws that hold the digit into place and test scoreboard. If problem persists
please contact Eversan, Inc.
Removing the Power Supply Box (in the front of the scoreboard):
1. Remove the access panel's four, 8-32 screws from the top and bottom of the panel.
2. Remove antenna (Wireless only). Slowly remove power supply.
3. Remove segment data ribbon cable connector.
4. Disconnect large 22/44-edge connector, it has an aluminum shroud, from the power supply by
rocking it gently up and down.
5. Unscrew the 5-wires from 8-pin terminal strip. Mark wire with location for future use.
Replacing the Power Supply Box:
1. Screw on the five power wires per marked code.
2. Reconnect 22/44-edge connector to side of power box.
NOTE: This is a polarized connector and is inserted in only one direction.
3. Replace segment data ribbon cable.
NOTE: this polarized connector is inserted in only one direction.
4. Before closing, install antenna (wireless only) and check out scoreboard.
EVERSAN, INC. • 34 Main Street, Whitesboro, NY 13492 • 1-800-383-6060 Fax: 315-736-4058
EVERSAN
Page 5
TROUBLESHOOTING PROCDURES
www.eversan.com
Advertisement
