Change The Programme; At The End Of The Wash Cycle - White Knight DW1260IA Instruction Manual

Turning On the Appliance
Starting a cycle wash
1 Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one (see the section entitled
Loading the Dishwasher ).
2 Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid ).
3 Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
4 Press the ON/OFF button, and the ON/OFF light will turn on. Press the program button to select
a desired wash cycle. Close the door,after 10 seconds, the machine will work.
Change the Program...
Premise
1 A cycle that is underway can only be modified if it has only been running for a short
time. Otherwise, the detergent may have already been released, and the appliance may
have already drained the wash water. If this is the case, the detergent dispenser must
be refilled (see the section entitled " Loading the Detergent " ).
2 Open the door a little to stop the washing. Press the programme button or the washing program more than 3
seconds to cancel the running programme. Then you can select other programmes (see the section entitled "
Starting a wash cycle. . . " ).
NOTE:
If you open the door during a wash cycle , the machine will pause. When you close the door ,
the machine will continue working after 10 seconds.
Forgot to Add a Dish?
A forgotten dish can be added any time before the detergent cup opens.
1
Open the door a little to stop the washing.
2
After the spray arms stop working, you can open the door
completely.
3
Add forgotten dishes.

At the End of the Wash Cycle

At the End of the Wash Cycle
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susceptible to breakage. They will also dry better.
Switch Off the Dishwasher
1.Switch off the dishwasher by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door carefully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
4
Close the door
5
The dishwasher will run after 10 seconds.
14