To Operate Drop Side Panel; Mattress Base Heights; To Lower Drop Side Panel; To Raise Drop Side Panel - Childcare Bristol Cot 091007 Manual

ASSEMBLY / OPERATING INSTRUCTIONS

To operate Drop Side Panel...

To Lower Drop Side Panel

1
1a.
To lower the drop side panel; lift upwards and
press both silver pins simultaneously on the left
and right of the drop side panel.
1b. The panel will then slide down freely.
1c. For safety, do not force the drop side panel to go
any lower.

To Raise Drop Side Panel

2
2a.
To raise the drop side panel, lift it to the highest
position.
The drop side panel will lock into position.
2b.

Mattress Base Heights...

Mattress base in High Position
The base height is set for when your baby is young and cannot
sit up unaided.
Mattress base in Low Position.
This is the normal position for an active baby who can sit up
unaided.
PLEASE NOTE! The cot comes with filling bolts already located in the lower holes of the end panels. If changing
the mattress base from the upper to the lower position, you must swap over the filling bolts. It is important that
the filling bolts are replaced into the opened holes. Ensure they are secured tightly with the allen key and check
regularly that they do not loosen.
For safe transit, the drop side panel is fitted with rubber cap protectors over each protruding pin. Please remove
the rubber caps prior to assembly, and dispose of immediately to avoid them becoming a swallowing/choking
hazard.
7