WTI RPC-4850 Series Quick Start Manual

Heavy duty dc network power switches
Hide thumbs Also See for RPC-4850 Series:

Advertisement

Quick Links

WTI Part No.: 13527
Rev.: B
RPC-4850 Series
Heavy Duty DC Network Power Switches
Quick Start Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RPC-4850 Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for WTI RPC-4850 Series

  • Page 1: Quick Start Guide

    WTI Part No.: 13527 Rev.: B RPC-4850 Series Heavy Duty DC Network Power Switches Quick Start Guide...
  • Page 2: Warnings And Cautions

    Warnings and Cautions: Installation Instructions Secure Racking If Secure Racked units are installed in a closed or multi-unit rack assembly, they may require further evaluation by Certification Agencies. The following items must be considered. 1. The ambient within the rack may be greater than room ambient. Installation should be such that the amount of air flow required for safe operation is not compromised.
  • Page 3: Hardware Installation

    Introduction This Quick Start Guide describes a simplified installation procedure for the RPC-4850 Series hardware, which will allow you to communicate with the unit in order to demonstrate basic features and check for proper operation. Note that this Quick Start Guide does not provide a detailed description of unit configuration or discuss advanced operating features in detail.
  • Page 4 RPC-4850 Series; Quick Start Guide NETWORK INPUT 10/100BASE-T RS232 INPUT DC/DC CONVERTER ISOLATED CONTROL POWER LOGIC SUPPLY LOGIC RL1 RL2 ... GROUND +24 VDC INPUT A 0 VDC +24 VDC INPUT B (CIRCUIT 0 VDC BREAKER) OUTPUT +24 VDC CKT 1...
  • Page 5 RPC-4850 Series; Quick Start Guide -48 VDC INPUT A 0 VDC -48 VDC INPUT B (CIRCUIT 0 VDC BREAKER) OUTPUT -48 VDC CKT 1 0 VDC -48 VDC OUTPUT CKT 2 0 VDC B BUS A BUS (-48 VDC) CIRCUITS 3 - 8 Figure 2: RPC-4850-48V;...
  • Page 6 RPC-4850 Series; Quick Start Guide Communicating with the RPC In order to ensure security, both Telnet and Web Browser Access are disabled when the RPC is shipped from the factory. To enable Telnet and/or Web Browser access, please refer to the RPC User's Guide. When properly installed and configured, the RPC will allow command mode access via Telnet, Web Browser, SSH client, modem, or local PC.
  • Page 7 RPC User’s Guide for important information regarding advanced configuration capabilities and more detailed operation instructions. If you have further questions regarding the RPC unit, please contact WTI Customer Support as described in the User’s Guide.
  • Page 8 5 Sterling • Irvine • California 92618 (949) 586-9950 • Toll Free: 1-800-854-7226 Fax: (949) 583-9514 • http://www.wti.com...

Table of Contents