System Information; View Memory; Bluetooth; Firmware Version - Mindeo MS3590 User Manual

Programmable mobile scanner
Hide thumbs Also See for MS3590:
Table of Contents

Advertisement

customized software development). When this option is enabled, system password is required when
switching from user application state back to system state.
If the user download the user customized application software, and enable the boot settings, the system
is run directly to the user's application when switched on. When user keep pressing the right soft key
during system booting stage, the system password is required before entering the system state. Entering
the system state is only allowed after the correct password is provided. Pressing the return key could
lead to the user customized application software state.
Notice: The default system password of the scanner is "1234".
Steps for setting the system password:
Step1. Enter the old (previous set) password for verification. Proceed to create new password stage if
correct password is provided, otherwise starts over.
Step2. Enter new password.
Step3. Re-enter the new password for verification.
Step4. If the newly entered passwords are identical then creation of new password is successful.

5-4 System Information

5-4-1 View Memory

User can view the used and remain memory capacity in Batch Mode.
Note: User can press Left Soft Key to erase data to release used memory.
Caution:
1. Erasing operation will delete all data in the memory.
2. Erasing operation is not undoable.

5-4-2 Bluetooth

User can view the name and address of the Bluetooth module.
Example:

5-4-3 Firmware Version

User can view the firmware version of the scanner, scan engine, and Bluetooth module.
32

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents