Mosa YANMAR GE 35 YSX Use And Maintenance Manual page 9

SAFETY PRECAUTIONS DURING MAINTENANCE
• Make use of qualified personnel to carry out maintenance
and troubleshooting.
• It is mandatory to stop the engine before performing any
maintenance on the machine.
• Always use protective devices and suitable equipment.
• Do not touch the engine, the exhaust pipes and the muffler
during operation or immediately after. Allow the engine to
cool before performing any operation.
• With the machine running pay attention to moving parts
such as fans, belts, pulleys.
• Do not remove the protections and the safety devices unless
absolutely necessary, restore them after completion of the
maintenance or repair.
• Do not refuel while the engine is running or hot. Do not smo-
ke or use naked flames when refueling.
• Refuel only outdoors or in well ventilated areas.
• Avoid spilling fuel, especially on the engine. Clean and dry
any leaks before restarting the machine.
• Slowly unscrew the cap of the fuel tank and put it back
always after refueling.
• Do not fill the tank completely to allow for expansion of the
fuel inside.
• Do not remove the radiator cap when the engine is running
or still hot, the coolant may spurt out and cause serious
burns.
• Do not handle the battery without the use of protective glo-
ves, the battery fluid contains sulfuric acid, which is very cor-
rosive and dangerous.
• Do not smoke, avoid any naked flames or sparks near the
battery, the vapors exhaled could cause the battery to explo-
de
GENERATING SETS - LIGHTING TOWERS
ADDITIONAL PRECAUTIONS FOR LIGHTING TOWERS
ATTENTION
!
The lighting towers is designed to be used with a generating
set or with a fixed mass on its base. The weight and positio-
ning of the generating set on the base are essential for the
safety of the lighting tower.
Failure to comply with this provision causes a serious danger
of tipping or instability during operation and during handling
with site tow If necessary, contact the service.
SAFETY PRECAUTIONS DURING HANDLING AND TRAN-
SPORTATION
• Before moving a lighting tower lower the telescopic mast
and block properly all movable parts such as the access do-
ors, the mast, the outriggers, the floodlights.
• Check the fastening of the wheels of the trolley.
SAFETY PRECAUTIONS DURING INSTALLATION AND
USE
• Make sure the area above the lighting tower is free from
overhead cables or other obstacles.
• Before raising the mast extract the outriggers located at
the sides of the machine. Acting on the outriggers level the
lighting tower making use of the bubble, so as to bring the
equipment in a horizontal position. Make sure that the to-
wer rests securely on the outriggers. If the lighting tower is
mounted on road trailer pull the handbrake.
• Do not operate the lighting tower if the wind speed exceeds
the safe speed indicated or if it is expected the arrival of
storms or thunderstorms in the area.
• Lower the telescopic mast when the tower is not used.
• Always check the good condition of the power cable before
connecting the lighting tower to the generating set.
• Do not touch and do not place objects on the lamps during
operation or immediately after use. The lamps become very
hot.
• Do not turn on the lamps without the protective glass or with
the same broken or damaged.
• Make sure all the ropes and the manual winch are in perfect
condition.
• Place the lighting tower in order to avoid that the winch can
receive shocks which may cause damage to the automatic
brake.
SAFETY PRECAUTIONS DURING MAINTENANCE
• Turn off the generating set or unplug the power cable before
carrying out any type of maintenance on the lighting tower.
• Always cut off power to the lamps and wait for their cooling
before performing any maintenance or replacement.
• Before carrying out any type of maintenance or repairs on
the generating set refer to the manual of the generating set
and the other manuals supplied.
9
SAFETY RULES
M
2.5.1