Belkin F5D6230-3 Quick Setup Manual
Belkin F5D6230-3 Quick Setup Manual

Belkin F5D6230-3 Quick Setup Manual

Wireless cable/dsl gateway router for mac
Hide thumbs Also See for F5D6230-3:

Advertisement

5. Select your connection type (this information is provided by your ISP) and click
"Select". Depending on your selection, you will see the "Static IP Address" page or
the "PPPoE" page. Enter the required values provided by your ISP and click "Enter".
6. The "MAC Cloning/Entry" screen will appear. If your ISP binds your connection to
the MAC address of your network adapter, click "Clone MAC Address" or enter the
MAC address here. Press "Enter".
Your Router has been set up to communicate with your ISP. You should have Internet
access at this point. If you are having trouble, see the "Troubleshooting" section in the
user's manual.
belkin.com
Belkin Components
Belkin Components, Ltd.
501 West Walnut Street
Unit 13 • Gatelodge Close • Round Spinney
Compton • CA • 90220 • USA
Northampton • Northants • NN3 8RX • United Kingdom
310.898.1100
+44 (0) 1604678300
© 2001 Belkin Components. All rights reserved. All trade names are registered trademarks of respective manufacturers listed.
Mac is a registerd trademark of Apple Computer, Inc.
Belkin Components, Ltd.
7 Bowen Cresent • West Gosford
NSW 2250 • Australia
+61 (2) 4372 8600
P73882
Wireless Cable/DSL
Gateway Router
Quick Setup Guide for Mac
Setting up the Router is accomplished in three easy steps:
1. Connect the Router to your network.
2. Configure your computer's TCP/IP settings.
3. Configure the Router to your ISP's settings.

Step 1: Connect the Router to your network

1. Power down your equipment.
2. Connect a network cable between each of your computers and the Router.
Connect each Mac to one of the ports on the rear of the Router labeled 1–3.
Do not connect a computer to the port labeled "WAN".
3. Connect a network cable between the Router and your cable or
DSL modem.
Be sure this cable is plugged into the port labeled "WAN" on the Router.
BELKIN
GATEWAY
ROUTER
4. Power on the cable or DSL modem.
®
F5D6230-3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the F5D6230-3 and is the answer not in the manual?

Questions and answers

Summary of Contents for Belkin F5D6230-3

  • Page 1 Northampton • Northants • NN3 8RX • United Kingdom 310.898.1100 +44 (0) 1604678300 © 2001 Belkin Components. All rights reserved. All trade names are registered trademarks of respective manufacturers listed. Mac is a registerd trademark of Apple Computer, Inc. Wireless Cable/DSL...
  • Page 2 5. Connect the power adapter to the Router. 6. After the cable or DSL modem and the Router are turned on, the Router’s WAN link light should be on. This indicates that the modem and the Router are connected to each other. 7.

This manual is also suitable for:

F5d6230-3englishmacquick

Table of Contents