Simplicity 204 Assembly Instructions

MODEL 725 RIDING TRACTOR
1. Remove varnish from moldboard and share, using
a good grade of varnish remover. (Keep greased when
not in use. )
2. Bolt standard ( 1 ) t o p l o w b o t t o m ( 2 ) .
3. Bolt beam ( 3 ) to standard at ( 4 ) . Lock with jam
nut so that beam is free to swing on standard.
4. Attach depth regulating yoke rod assembly ( 5 ).
Pin and cotter pin.
5 . A t t a c h r o l l i n g c o u l t e r a s s e m b l y ( 6 ) a n d a d j u s t
coulter standard ( 7 ) so that blade runs approximately
for best depth depending upon the soil.
NOTE: REPOSITION BEAM END TO THESE HOLES, WHEN
USING PLOW WITH 2-WHEEL TRACTORS.
o p p o s i t e
ASSEMBLY AND ADJUSTMENT
CAUTION: Be sure that the rolling, coulter is out of
the ground when the tractor is in reverse gear.
beam at ( 8 ) by means of the pin and spring clip pro-
vided. The hitch clevis adapter ( 10 ) is then attach-
ed to the tractor hitch by means of the pivot pin.
assembly and secure in place with a pin and s,pring
c l i p .
7. Wheel weights should be used when operating the
10" Plow. The weights are designed so that as many
weights as necessary may be added to the wheels
M A N U F A C T U R I N G
10" HEAVY
DUTY PLOW
the plow is used H r i t h t h e "725",
P l o w B e a m A s s e m b l y a f t e r m o v i n g t h e
to outside of Beam Assem-
o f S p a c e r
LANDLORD RIDING TRACTOR
C O M P A N Y ,
of the