Table of Contents
Advertisement
4 Assembly and installation [specialist]
4 Assembly and installation [specialist]
The HeatBloC K35 can be mounted on a PAW modular distribution manifold or on a wall
bracket. The modular distribution manifold and the wall bracket are optional accessories
and are thus not included in the scope of delivery.
The distance between the pipe axis of the HeatBloC and the wall must be at least 10 cm,
as the connection C-3 is on the back side of the mixing valve.
NOTICE
Damage to property!
The location of installation must be dry, load-carrying, frost-proof and protected against
ultraviolet radiation in order to prevent material damage of the installation.
4.1
Accessories: Cutting-ring compression fitting (not included in the scope of delivery)
The connection to the heating installation can be carried out fast, pressure-proof and
without soldering if you use the optionally available compression fittings.
Not included in
the scope of delivery!
2017/01
1. Push the union nut ② and the cutting ring ③ onto the
copper pipe ① . The pipe must protrude at least 3 mm
from the cutting ring in order to ensure the force
transmission and the sealing.
2. Insert the support sleeve ④ into the copper pipe.
3. Insert the copper pipe with the plugged-on individual
parts (②, ③ and ④) as far as possible into the
housing of the compression fitting ⑤.
4. First, screw the union nut ② manually.
5. Tighten the union nut ② by rotating one full turn.
Secure the housing of the compression fitting ⑤
against distort, in order to avoid damaging the
sealing ring.
9936093x-mub-en – V01
13
Advertisement
Table of Contents
