Removing The Interface Qos Limit From The Tcam; Configuring A Service Policy On A Vlan - Cisco Nexus 5000 NX-OS Service Configuration Manual

Removing the Interface QoS Limit from the TCAM

Removing the Interface QoS Limit from the TCAM
Before You Begin
• Remove all VLAN QoS policies.
Procedure
Step 1
Step 2
Step 3
Step 4
This example shows how to remove the interface QoS TCAM limit:
switch(config)# configure terminal
switch(config)# show hardware profile tcam feature qos
Feature
------------------------------------------------------
interface-qos
vlan-qos + global-qos
switch(config)# no hardware profile tcam feature interface-qos limit 20
switch(config)# copy running-config startup-config

Configuring a Service Policy on a VLAN

Before You Begin
• You must configure the interface QoS limit.
• You must configure a policy map.
• The TCAM must have enough free entries to configure the service policy on the VLAN.
Cisco Nexus 5000 NX-OS Quality of Service Configuration Guide, Release 5.1(3)N2(1)
54
Command or Action
switch# configure terminal
switch(config)# show hardware profile
tcam feature qos
switch(config)# no hardware profile tcam
feature interface-qos limit tcam-size
switch(config)# copy running-config
startup-config
Limit (number of tcam entries)
20
428
Configuring QoS on VLANs
Purpose
Enters global configuration mode.
Displays the limits of the QoS TCAMs.
Configures the interface QoS TCAM limit. The
tcam-size range is from 7 to 446 entries.
(Optional)
Saves the change persistently through reboots and
restarts by copying the running configuration to
the startup configuration.
OL-26657-01