Important Service Notes (For U.s.a. Only); Specifications - Sharp CD-C602 Service Manual

CD-C602,CP-C602
FOR A COMPLETE DESCRIPTION OF THE OPERATION OF THIS UNIT, PLEASE REFER
TO THE OPERATION MANUAL.

IMPORTANT SERVICE NOTES (FOR U.S.A. ONLY)

BEFORE RETURNING THE AUDIO PRODUCT
(Fire & Shock Hazard)
Before returning the audio product to the user, perform the
following safety checks.
1. Inspect all lead dress to make certain that leads are not
pinched or that hardware is not lodged between the chassis
and other metal parts in the audio product.
2. Inspect all protective devices such as insulating materials,
cabinet, terminal board, adjustment and compartment
covers or shields, mechanical insulators etc.
3. To be sure that no shock hazard exists, check for leakage
current in the following manner.
* Plug the AC line cord directly into a 120 volt AC outlet.
* Using two clip leads, connect a 1.5k ohm, 10 watt resistor
paralleled by a 0.15µF capacitor in series with all exposed
metal cabinet parts and a known earth ground, such as
conduit or electrical ground connected to earth ground.
* Use a VTVM or VOM with 1000 ohm per volt, or higher,
sensitivity to measure the AC voltage drop across the
resistor (See diagram).
* Connect the resistor connection to all exposed metal parts
having a return path to the chassis (antenna, metal cabinet,
screw heads, knobs and control shafts, escutcheon, etc.)
and measure the AC voltage drop across the resistor.
CD-C602
General
Power source: AC 120 V, 60 Hz
Power consumption: 25 W
Dimensions: Width; 10-5/8" (270 mm)
Height; 11-1/16" (280 mm)
Depth; 13-1/8" (332.5 mm)
Weight: 9.2 lbs. (4.2 kg)
Amplifier section
Output terminals: Headphones; 16-50 ohms
(recommended; 32 ohms)
Front speaker ; 6 ohms
Rear speaker ; 12 ohms
Tuner section
Frequency range: FM; 87.5-108 MHz
AM; 530-1,720 kHz
Cassette deck section
Frequency response: 50-14,000 Hz (Normal tape)
Signal/noise ratio: 50 dB (TAPE 1, recording/playback)
55 dB (TAPE 2, playback)
Wow and flutter: 0.15 % (WRMS)
Compact disc player section
Type: 3-disc multi-play compact disc player
Signal readout: Non-contact, 3-beam semiconductor
laser pickup
D/A converter: 1-bit D/A converter
Frequency response: 20 -20,000 Hz
Dynamic range: 90 dB (1 kHz)
All manuals and user guides at all-guides.com

SPECIFICATIONS

– 2 –
VTVM
AC SCALE
1.5k ohms
10W
0.15µF
TEST PROBE
TO EXPOSED
METAL PARTS
All check must be repeated with the AC line cord plug connection
reversed.
Any reading of 0.3 volt RMS (this corresponds to 0.2 milliamp.
AC.) or more is excessive and indicates a potential shock
hazard which must be corrected before returning the audio
product to the owner.
CP-C602
Front speaker section
Type: 4" (10 cm) full-range speaker
Maximum input
power: 5 W
Impedance: 6 ohms
Dimensions: Width; 6-11/16" (170 mm)
Height; 11-1/16" (280 mm)
Depth; 5-15/16" (151 mm)
Weight: 3.1 lbs. (1.4 kg)/each
GBOXS0020AWM1
Rear speaker section
Type: 3-3/32" (8 cm) full-range speaker
Maximum input
power: 4 W
Impedance: 12 ohms
Dimensions: Width; 6" (150 mm)
Height; 6" (150 mm)
Depth; 3" (78 mm)
Weight: 0.9 lbs. (0.4 kg)/each
Specifications for this model are subject to change without prior
notice.
CONNECT TO
KNOWN EARTH
GROUND