Network - Vertiv Liebert IntelliSlot WEBRT3N User Manual

Warning Will be Initiated _ Before Schedule Shutdown Event
The IS-WEBRT3N card will send a warning message before a scheduled shut-down. This section sets the
delay time after the message is sent until the scheduled shut-down begins.

4.3.3 Network

This page is used to set the IS-WEBRT3N card Network settings.
IPv4
IP Address—sets the IS-WEBRT3N card IP address.
Subnet Mask—sets the IS-WEBRT3N card Subnet Mask.
Gateway—sets the IS-WEBRT3N card Gateway.
Obtain an IP address—chooses to set IS-WEBRT3N card IP address manually or via DHCP.
The four sections above can be set in Liebert DeskPro-Net as well. The IS-WEBRT3N card will reboot after
any of the above are changed.
NOTE: If the IP address and DNS have been configured on Netility, then the information will
automatically be shown on this page.
Primary DNS Server IP—sets the IS-WEBRT3N card primary DNS Server IP address.
Secondary DNS Server IP—sets the IS-WEBRT3N card secondary DNS Server IP address. The IS-
WEBRT3N card will use the secondary DNS Server IP address when the Primary DNS Server IP address is
not working.
IPv6
IP address—Network address for the interface.
IPv6 Prefix—Prefix length for the address that divides a network into manageable segments.
Gateway—IP address of the gateway for network traffic destined for other networks or subnets.
Obtain an address—Mode the card boots into to be a network ready device (Static, Auto)
Router Discovery Autoresend—Enable or disable autoresend.
Maximum Number of IPv6 Prefix—The maximum length for the address that divides a network into
manageable segments.
Multicast Address: Specifies the host extensions for IP multicasting.
Primary DNS Server—primary DNS server
Secondary DNS Server—secondary DNS server.
NOTE: Clicking Apply will reboot the NetAgent.
Vertiv | Liebert® IS-WEBRT3N™ Card User Manual | 15