Travel Limit Settings; Programming; Program Remote Control; Erase All Codes - Chamberlain LA350 Installation Manual

from all persons and must not be collocated or operating The antenna(s) used for this must be installed to provide a separation distance of at least 20 cm

TRAVEL LIMIT SETTINGS

1. Release the clutch on both operators with the release key. Open both gates completely, then engage
the clutches.
2. Set DIP switch S1 No. 8 to ON position.
3. Press button
gate leaves will close completely.
4. Press button
5. Set DIP switch S1 No. 8 to OFF position.

PROGRAMMING

Program Remote Control

1. Press and release the LEARN button
2. Press the desired button on the remote control to program it to the operator.
The operator will automatically exit learn mode (LED1 will fl ash and go out) if programming is
successful. To program additional Security✚ 2.0™ remote controls or remote control buttons, repeat
the programming steps above. Press the LEARN button a second time to exit programming at any time.
NOTICE: Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Any changes or modifi cations not expressly approved by the party responsible for this product could void the user's authority to operate the
equipment.
This device is designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to:
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The antenna(s) used for this must be installed to provide a separation distance of at least 20 cm from all persons and must not be collocated
or operating in conjunction with any other antenna or transmitter, except in accordance with FCC multi-transmitter product procedures.

Erase All Codes

1. Press and hold the LEARN button
2. Hold the LEARN button for approximately 6 seconds. LED1 will go out and all remote control codes
are now erased.
on the control board, both
SBC
again, both gate leaves will open completely.
SBC
LEARN
S1
, LED1 will light.
LEARN
, LED1 will light.
18
1 2 3 4 5 6 7 8
ON
OFF