Advertisement
Diagram 2
TYPICAL INSTALLATION
Flexible duct
The Shower Fan to be hung
or screwed to the joist
Internal
Extract-a-Lite/
Extract-a-LED
Installation Instructions
Important: The Halogen model Extract-a-Lite must not work independently of the fan.
1. Cut a 165mm diameter hole in ceiling, (always ensure the hole is cut between ceiling rafters and away
from any wiring or plumbing). Fix the chassis using the 4 screws provided. Use the fixing clips to secure
the grille (See diagram 1).
2. Connect the duct to the spigot of the chassis.
3. For the LED models: Connect LED driver to the Extract-a-LED and to a suitable power supply,
ideally to the switched live of the extractor fan installed. Recommended driver: FAN5342.
Replacement lamp: LHT0221
For the Halogen models: Connect a suitable transformer to the Extract-a-Lite and to a suitable
power supply, ideally to the switched live of the extractor fan installed. Recommended transformer:
FAN2101. Recommended lamp: FAN0431
4. Place the ceiling cover onto the chassis by locating onto the 3 lugs, and twisting clockwise.
5. Never connect mains direct to the lamps.
6. The transformer/driver must be suitable for 230V AC input.
CAUTION: Disconnect the power supply, and be sure that the lamp has fully cooled before removing
or replacing.
IMPORTANT
• Isolate the mains supply before making any electrical connections. This system should be
installed by a qualified electrician.
• When fitting through an external wall, an external grille must be fitted at all times.
External Grille
• Fan should only be installed by fixed wiring, a flexible cord should not be used.
• The appliance is not intended for use by young children or infirm persons without supervision.
• Young children should be supervised to ensure that they do not play with the appliance.
• Precautions must be taken to avoid the back-flow of gases into the room from the open flue
of gas or other open-fire appliances when mounted in outside windows or walls.
Advertisement
