Setting Up The Toilet; Installing Ct Models - Dometic CT4050 Installation Manual

Installing the toilet
5.3

Setting up the toilet

A
NOTICE!
All components of the system must be installed in frost-free areas. In
freezing temperatures, there is a risk of damage caused by frost.
I
NOTE
• When installing the toilet in a wet room, the manufacturer recom-
mends that you connect the toilet to the shower tray.
• The toilet base is equipped with a protruding collar for receiving the
upper edge of the shower tray (fig. 4, page 4).
➤ Install the toilet according to the description for the respective model version.
➤ Set up the toilet so that it is flush to a vertical wall only.
➤ Leave enough space so that actuation of the draining slider is not restricted.
➤ For the installation, use the dimensional drawings:
– CT4050, CT4110: fig. 5, page 5
– CTLP4050, CTLP4110: fig. 6, page 6
– CTS 4050, CTS4110: fig. 7, page 7
– CTW4050, CTW4110: fig. 8, page 8
5.4

Installing CT models

The detached model CT4xxx has no integrated water tank and no console. Set up
this model so that the wall behind it can accommodate the control unit of the toilet,
the electrical connections and possibly a water tank. It is best if you put a box in front
of the room wall (fig. 9, page 9).
Note here that the cassette protrudes 110 mm out of the cassette housing (fig. 0 a,
page 9). The base height is between 50 and 110 mm, depending on model
(fig. 0 b, page 9).
➤ Align the toilet according to the service door.
➤ Place the housing base flush with the installation box so that there is a clean
transition and no gap.
26
CT4000
EN