American Standard Comrade Installation Instructions Care And Maintenance

INSTALLATION INSTRUCTIONS
CARE AND MAINTENANCE
WALL HUNG SINK
NOTE: For installation of models using concealed or exposed arms, follow instruction provided by arms manufacturer.
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product is installed
properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be
sure your installation conforms to local codes.
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE: Pictures may not exactly define contour of china and components.
OBSERVE LOCAL PLUMBING AND BUILDING CODES
Recommended Tools & Materials
Putty Knife
Pipe Wrench
Level Channel Lock Pliers
1
Provide suitable reinforcement behind
finished wall for lavatory hanger mounting
*
screws. Determine horizontal center line
location of support from the table listed in
Step 2. (Make sure support bottom
extends to lavatory back wall bottom.)
NOTE: If replacing an existing sink be
certain to shut off water supply before
removing old sink.
Hanger
C/L of 2x8
Location
Support
*
Finished
Floor
3
Position hanger according to Step 2,
making sure its center is aligned
with the waste hole centerline.
Mark the hanger screw locations
through its mounting holes.
Pro d u ct name s lis ted h ere in are
tra d e m ar ks of AS A me r ica, Inc.
© AS Am er ica, Inc. 2015
Adjustable Wrench
Plumbers' Putty or Caulking
Drill
Tubing Cutter
Phillips Screwdriver
2
Determine the
desired rim height
(for example 32")
then select from the
Table at right the
height of the hanger
mounting bolts
centerline
EXAMPLE:
For Lucerne:
32"-1"= 31"
For Missouri:
32"+1"= 33"
4
Drill pilot holes in positioning screw
slots of hanger. (Note: Some models
are supplied with anchor screws, or
steel hangers for lavatory installations.
Other models are not provided with
mounting hardware which can be
purchased at local hardware outlets.
Lavatories with bottom anchor screw
holes should be secured with anchor
screws in addition to hangers.
Basin Wrench
Saber Saw
Regular Screwdriver
TABLE
Part # Model
0124 Comrade
0321 Declyn
0355/0356 Lucerne
0372/0373 Penlyn
4867/4869 Regalyn
0436 Missouri
9024 Decorum
C/L OF HANGER ANCHORING SLOTS
A
RIM
HEIGHT
*
WASTE
FINISHED FLOOR
MOUNTING
Tape
Measure
Hacksaw
Distance "A"
- 2-1/2" (64mm)
- 2-3/4" (70mm)
- 1" (25mm)
- 1/8" (3mm)
+ 2-3/4" (70mm)
+ 1" (25mm)
- 3-11/16" (93mm)
HANGER
HOLES FOR
ANCHOR SCREWS
IN BACK DRAPERY
SUPPLIES
AS REQUIRED
SCREW
HOLES (4)
POSITIONING
SCREW
SLOTS (2)
7 3 0 4 2 7- 10 0 Rev. E