Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Brilliant Fires Limited NEWDAWN ELECTRIC 2 SERIES
Summary of Contents for Brilliant Fires Limited NEWDAWN ELECTRIC 2 SERIES
- Page 1 USER AND INSTALLATION INSTRUCTIONS Please read these instructions before installation and use. Keep this booklet handy for future reference. This appliance should only be installed by an appropriately qualified person. NEWDAWN ELECTRIC SERIES 2...
- Page 2 [Blank]...
-
Page 3: User Guide
USER GUIDE Please read these instructions before installation and use. Keep this booklet handy for future reference. This appliance should only be installed by an appropriately qualified person. WARNING CONTENTS USER GUIDE WARNINGS AND SAFETY INFORMATION CONTROLS GUARANTEE SERVICING INSTRUCTIONS... - Page 4 Brilliant Electric fires meet the requirements of This appliance is supplied with a two metre power the EC Directives 2004/108/EC and 2006/95/EC. lead which has a moulded three pin socket to These directives have been met by compliance connect to the appliance power inlet plug. with the following standards: Depending on the model, the power lead may have BS EN 60335-1:2002...
- Page 5 As these colours may not correspond with the The current temperature position (Figure 2) will be coloured markings identifying the terminals in displayed with each press of any button. This your plug or fused spur, proceed as follows: shows that the handset is transmitting a signal to the fire.
- Page 6 HEATER OVERRUN MODE THERMAL CUT-OUT The heater on this appliance is equipped with a In case of overheating the heater and fan will system that cools the heater down before automatically turn off. To reset the thermal cut- switching off the fan. This Overrun lasts for 2 out, the appliance must be turned off at the fused minutes with the fan running only.
- Page 7 HANDSET BATTERY REPLACEMENT MANUAL CONTROL VERSION To replace the batteries in the remote handset The controls are located on the right edge of the first remove the screw from the rear of the appliance. The right control is the on/off switch; handset.
- Page 8 GUARANTEE Brilliant appliances are manufactured in England. The appliance is guaranteed for 12 months from the date of purchase against faulty materials or workmanship. Please report any fault to your dealer. If your appliance is found to be defective within the guarantee period we will repair or replace the faulty component.
-
Page 9: Servicing Instructions
INSTALLATION AND SERVICING INSTRUCTIONS Please read these instructions before installation. Give this booklet to the user for future reference. This appliance should only be installed by an appropriately qualified person. WARNING CONTENTS INSTALLATION AND SERVICING INSTRUCTIONS WARNINGS AND SAFETY INFORMATION SITING THE APPLIANCE AND INSTALLATION SERVICING WIRING DIAGRAM... - Page 10 Brilliant Electric fires meet the requirements of during maintenance and cleaning. the EC Directives 2004/108/EC and 2006/95/EC. These directives have been met by compliance This appliance is supplied with a two metre power with the following standards: lead. Depending on the model, the power lead may BS EN 60335-1:2002 have a moulded three pin 13 amp-fused plug to BS EN 60335-2-30:2003...
- Page 11 SITING THE APPLIANCE This appliance may be fixed to any suitable flat The fixing kit and the power supply lead are tied in vertical non-conductive surface and does not place at the bottom right of the wall plate. Remove require a cut out in the wall. The appliance must these before commencing fitting.
- Page 12 Using a spirit level, check the appliance is level. FIRE SURROUND Fine adjustments can be made to correct the level before tightening the two screws. Drill two holes for wall plugs through the left and right fixing holes at the bottom of the appliance. Insert and tap into position the two remaining wall plugs and HANG SURROUND ON HERE fix with the two remaining screws.
- Page 14 SERVICING ! RISK OF ELECTRIC SHOCK ! ! RISK OF ELECTRIC SHOCK ! ! RISK OF ELECTRIC SHOCK ! ! RISK OF ELECTRIC SHOCK ! DO NOT DO NOT remove any cover of this DO NOT DO NOT appliance unless the electricity WARNING supply has been disconnected.
- Page 15 AUTO REMOTE WIRING DIAGRAM TEMPERATURE SENSOR BLACK BLACK EARTH SUPPLY BLACK BROWN BLACK BLUE BLACK BROWN...
- Page 16 MANUAL CONTROL WIRING DIAGRAM...
- Page 17 [Blank]...
- Page 18 [Blank]...
- Page 19 [Blank]...
- Page 20 Brilliant Fires Limited Thwaites Close Blackburn BB1 2QQ England tel +44 (0)1254 682384 fax +44 (0)1254 672647 www.brilliantfires.co.uk info@brilliantfires.co.uk 08 01 2014...
Need help?
Do you have a question about the NEWDAWN ELECTRIC 2 SERIES and is the answer not in the manual?
Questions and answers