Advertisement
UNIVERSAL CROSS BAR SYSTEM
UNIVERSAL CROSS BAR SYSTEM
Warnings / Limitations: The load you are carrying plus the weight of the
rack must not exceed the maximum weight limitation of the vehicle's
factory rack. Before installing, confirm your vehicle's factory specification.
Installation & Loading Instructions - Please Read Before Beginning
1
. Lift the forward section of the tower
to adjust it's position. Center towers
over the side rails. See image 2.
3
MALONE
Cross Bars with Locks & End Caps
Rubber Spacer Blocks
Step 1: Vehicle Installation
. Remove the Cross Bars and components
from the packaging. Using the Key, unlock
and slide the locking plate down. Insert
the Installation Wrench into the bolt and
turn counter clockwise to widen the
capture distance of the feet. See image 1.
2
. Place Cross Bars onto the vehicle's raised
side rails. Adjust for the load to be carried.
Note: Bars must be separated by a minimum
of 24". See image 3.
R
Keys
Installation Wrench
Advertisement
Table of Contents
Related Manuals for Malone MPG201
Summary of Contents for Malone MPG201
- Page 1 MALONE UNIVERSAL CROSS BAR SYSTEM UNIVERSAL CROSS BAR SYSTEM Cross Bars with Locks & End Caps Rubber Spacer Blocks Keys Installation Wrench Warnings / Limitations: The load you are carrying plus the weight of the rack must not exceed the maximum weight limitation of the vehicle’s factory rack.
- Page 2 Malone Universal Rack Guidelines . Never assume a cross bar will fit. Always refer to Malone’s Fit Guide for proper, correct and approved vehicle fit. . Confirm that all bolts and locks are firmly secured prior to transport. Periodically check the load during transport.
- Page 3 If the original retail purchaser is unable to contact the Malone dealer, or the dealer is not able to remedy the defect, the original retail purchaser should contact Malone by email at technical@maloneautoracks.com.
Need help?
Do you have a question about the MPG201 and is the answer not in the manual?
Questions and answers