Functions - Toshiba teli CleverDragon Series Instruction Manual

9. Functions

By accessing the camera register published on the camera link I/F, you can control/set each function.
Since access to the camera register is performed via the frame grabber board, the controlling and setting methods
differ depending on the frame grabber board you use. For details, refer to the instruction manual of the relevant
frame grabber board or contact our sales representative.
This instruction manual describes the specifications in the case where the camera register is directly connected by
serial transmission over the camera link interface.
9.1 Explanation of Each Function
(1) Register setting value updating
The changed register setting value is reflected on the camera operation.
Only writing a value in each register does not cause the value to be reflected on the camera operation.
Register value updating must be executed before the changed setting value can be reflected on the camera
action.
To save the setting value in memory, the register setting value must be updated beforehand. Otherwise, an
execution error occurs and the setting value is unable to be saved in memory.
(2) Readout mode
Video is output from the camera link connector. The output video can be grabbed by the frame grabber board.
The frame rate and resolution of output images that this model supports are as follows:
1) All pixel readout
2) Partial scan
3) High-speed draft readout : Approximately 89 fps / 1628(H) x 309(V)
1) All pixel readout
Reads out all pixels in about 1/30 second.
FVAL
LVAL
DVAL
DATA OUT
A d d r e s s ： 0 x 6 E , B i t ： 0 , V a l u e : 1
: Approximately 30 fps / 1628(H) x 1236(V)
: Approximately 30 to 183 fps / 1628(H) x 552(V) to 1236(V)
A d d r e s s ： 0 x 7 0 , B i t ： 0 , V a l u e : 0 a n d A d d r e s s ： 0 x 8 1 , B i t ： 0 , V a l u e : 0
1250H
6
Rev 3.0
D4161841C