Machine Adjustment And Setup; Replace The Sanding Belts; Adjust The Sanding Belt - Baileigh Industrial ES-9138 Operator's Manual

MACHINE ADJUSTMENT AND SETUP

Replace the Sanding Belts

1. Disconnect the machine from power source.
2. Open the guard on the sanding unit.
3. Shift the sanding belt lever (A) to release the
sanding belt tension according to the indicant
direction.
4. Take out the old sanding belt.
5. Replace the new sanding belt.
6. Shift the sanding belt lever (A) to tighten the
sanding belt tension according to the indicant
direction.
7. Make the sanding belt adjustment.
8. Close the guards.
CAUTION:
footwear, and leather gloves to protect from, chips, dust, burrs, and slivers.

Adjust The Sanding Belt

After the sanding belt has been replaced it is the necessary to check that the sanding belt is in
the middle of the drive roller. If not, the sanding belt must be adjusted.
1. Loosen the jam nut (A).
2. Turning the adjustment knob (B) counter-clockwise
will cause the sanding belt to move upward.
3. Turning the adjustment knob (B) clockwise will
cause the sanding belt to move downward.
4. When the belt is running in the middle of the bed,
hold the adjustment knob in position and tighten the
jam nut (A).
Always wear proper eye protection with side shields, safety
19
19