Table of Contents
Advertisement
11. Respiratory Protection. Wear an approved dust mask or respirator while using this
machine. Continued exposure to wood dust can cause allergies or long term respiratory
problems.
12. Do not overreach. Maintain proper footing and balance at all times. DO NOT reach over or
across a running machine.
13. Stay alert. Watch what you are doing and use common sense. DO NOT operate any tool or
machine when you are tired.
14. Check for damaged parts. Before using any tool or machine, carefully check any part that
appears damaged. Check for alignment and binding of moving parts that may affect proper
machine operation.
15. Observe work area conditions. DO NOT use machines or power tools in damp or wet
locations. Do not expose to rain. Keep work area well lighted. DO NOT use electrically
powered tools in the presence of flammable gases or liquids.
16. Keep children away. Children must never be allowed in the work area. DO NOT let them
handle machines, tools, or extension cords. Keep visitors a safe distance from the work
area.
17. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit rust.
Always lock up tools and keep them out of reach of children.
18. DO NOT operate machine if under the influence of alcohol or drugs. Read warning
labels on prescriptions. If there is any doubt, DO NOT operate the machine.
19. Watch for fire and keep a fire extinguisher close by.
20. DO NOT touch live electrical components or parts.
21. Turn off power before checking, cleaning, or replacing any parts.
22. Be sure all equipment is properly installed and grounded according to national, state, and
local codes.
23. Inspect power and control cables periodically. Replace if damaged or bare wires are
exposed. Bare wiring can kill! Keep all cords dry, free from grease and oil, and protected
from sparks and hot metal.
24. DO NOT bypass or defeat any safety interlock systems.
25. Know the location of the ON - OFF switch and the "E"- STOP button.
26. Reduce the risk of unintentional starting. Make sure switch is in "OFF" position before
plugging in power cord.
27. Never leave machine running unattended. TURN POWER OFF. Don't leave machine
until it comes to a complete stop.
28. Minimum Stock Dimensions. DO NOT sand material thinner than 1/16" (1.5mm), narrower
than 1/8" (3mm), or shorter than 8" (203mm).
8
8
Advertisement
Table of Contents
