Health And Safety - ABB ControlMaster CMF Manual

Health & Safety
Safety precautions
Be sure to read, understand and follow the instructions contained within this manual before and during use of the equipment.
Failure to do so could result in bodily harm or damage to the equipment.
WARNING Installation and maintenance of this product must only be conducted by personnel authorized to work on
electrical installations and in accordance with relevant local regulations.
Potential safety hazards
Electrical
WARNING To ensure safe use when operating this equipment, the following points must be observed:
– Up to 240V AC may be present. Be sure to isolate the supply before removing the terminal cover.
– Normal safety precautions must be taken to avoid the possibility of an accident occurring when operating in conditions of
high pressure and / or temperature.
Safety advice concerning the use of the equipment described in this manual or any relevant Material Safety Data Sheets (where
applicable) can be obtained from the Company, together with servicing and spares information.
Safety standards
This product has been designed to satisfy the requirements of IEC61010-1:2010 3
Equipment for Measurement, Control and Laboratory Use' and complies with US NEC 500, NIST and OSHA.
Safety conventions
WARNING In this manual, a warning is used to indicate a condition which, if not met, could cause serious personal injury
and / or death. Do not proceed beyond a warning until all conditions have been met.
CAUTION A caution is used to indicate a condition which, if not met, could cause minor or moderate personal injury and / or
damage to the equipment. Do not proceed beyond a caution until all conditions have been met.
NOTE A note is used to indicate important information or instructions that should be considered before operating the
equipment.
EC Directive 89/336/EEC
Electrical – In order to meet the requirements of the EC Directive 89/336/EEC for EMC regulations, this product must be used in an
industrial environment.
End-of-life disposal
The recorder contains a small lithium battery that must be removed and disposed of responsibly in accordance with local environmental
regulations.
The remainder of the recorder does not contain any substance that causes undue harm to the environment and must be disposed of in
accordance with the Directive on Waste Electrical and Electronic Equipment (WEEE). It must not be disposed of in Municipal Waste Collection.
Cleaning
The complete recorder can be hosed down if it has been installed to IP66 / NEMA 4X standards – see section 2, page 5.
Warm water and a mild detergent can be used.
2
rd
edition 'Safety Requirements for Electrical
CI/CMF160/310–EN Rev. C