IBC P-271 Installation Instructions

Safety ignition module+ (sim+) replacement kit

P-271 Safety Ignition Module+ (SIM+) replacement kit

The kit replaces an existing SIM+ module.

IBC Part #

P-271

Safety Ignition Module+ (SIM+)

Warning

This kit shall be installed by a qualified service agency in

accordance with the manufacturer's instructions and all applicable

codes and requirements of the authority having jurisdiction. If the

information in these instructions is not followed exactly, a fire, an

explosion or production of carbon monoxide may result causing

property damage, personal injury or loss of life. The qualified service

agency is responsible for the proper installation of this kit.

Kit contents:

A. SIM+ module configured to Fenwal mode - # 500-078

B. 2 x screws - 6-32 x 5/8" - # 150-015

Note

For increased reliability, we recommend that you replace the ignitor (purchased separately) at the same time as

the SIM. However, ignitors with low running hours can be reused. See

120-284R3

4/4/2018

Installation Instructions

Description

SL 10-85 G3, SL 14-115 G3, SL 20-160 G3, SL 30-199 G3

www.ibcboiler.com

Boiler Model

│ 1

Table of Contents

Need help?

Do you have a question about the P-271 and is the answer not in the manual?

Page 1 Installation Instructions P-271 Safety Ignition Module+ (SIM+) replacement kit The kit replaces an existing SIM+ module. IBC Part # Description Boiler Model P-271 Safety Ignition Module+ (SIM+) SL 10-85 G3, SL 14-115 G3, SL 20-160 G3, SL 30-199 G3 Warning This kit shall be installed by a qualified service agency in accordance with the manufacturer’s instructions and all applicable...
Page 2 clips click into place properly. Each wire Installing a SIM+ connector plug should fit snugly into a socket. 9. (Optional) To replace the ignitor: a. Unscrew the two Phillip head screws holding the ignitor in place. b. Position the new ignitor and gasket in place, and attach using the two ignitor screws supplied with the kit.
Page 3 2. Remove the ignition wire and ground wire from the ignitor. 3. Remove the two mounting screws holding the ignitor in place, and retain them. 4. Remove the existing ignitor and gasket, and replace with the new parts. 5. Install the retained mounting screws and firmly tighten.