Table of Contents
Advertisement
HIGH QUALITY AND LEADING ARTICLE IN THE
BILL COUNTER
6.Error message and solution
The batch display may shows some error message when counting, which means there are some problems with the machine.
Refer to the following diagram to find way to solve it.
Message
Error
Suspicious bill detected by UV system;
( A )
Problem in the UV system
Suspicious bill detected by UV system;
( A )
Problem in the UV system
Suspicious bill detected by MG system;
( b )
Problem in the MG system
Suspicious bill detected by IR system;
( r )
Problem in the IR system
11
Solution
Remove the last bill from the stacker,press
"RSTART"to continue;lower the UV sensitivity.
Remove the bill before last from the stacker,press
"RSTART"to continue;lower the UV sensitivity.
Remove the suspicious bill from the stacker ,
press "RESTART" to continue;
Lower the MG sensitivity
Remove the suspicious bill from the stacker ,
press "RESTART" to continue;
Lower the IR sensitivity
HIGH QUALITY AND LEADING ARTICLE IN THE
BILL COUNTER
7.Trouble shooting
When an error occurs, its corresponding error code is displayedon the Batch Number Display. Find the cause of error by
the displayed error code and remove the cause according to the following procedure.
Type of error
Error code
Cause of error
EJ
A note is jammed
in the machine
Jam
( E J )
Double note detection
Abnormal notes in
(Ed)
mixed in the bundle
Eh
of notes to be
Half note detection
(EH)
counted.
EC
Chained note detection
(EC)
Note(s) is remains in the
Note is in the Stacker
(St)
Stacker.
Procedure for the removing the cause of the error
1.Remove notes from in the Hopper
2.Set all the removed notes into the Hopper
again.
3.Restart counting operation by pressing the
"RESTART"key.
Check all the notes on the Hopper. then set them again Press the
"RESTART" key toStart counting operation.
Remove the note(s) left in the stacker.
12
Advertisement
Table of Contents
