Assembly Instructions - Nova Caddy X9R User Manual

2. Assembly Instructions

Please read and follow these instructions carefully, and you will be ready to go
in a few minutes.
1.Unpack all items carefully and check everything has been included. Some
extras may be in small packages so do not throw anything away until all has
been checked.
2. Place the frame structure (one piece) on soft and clean floor and ensure you
do not scratch the frame on a hard surface.
3. Fit the rear wheel by releasing the quick catch on the outside of the wheel
while inserting the wheel onto the axle. Push the wheel all the way in so that
the two pins on the axle fit into the wheel to engage the clutch and release the
quick catch. The wheel should be fully secured. If not locked in, the wheel will
not be connected to the clutch and will not be propelled!!! Test the lock by
trying to pull the wheel out. To disassemble the wheels proceed in reverse
order. If you feel the wheels are not working then take them off – switch the
power on and if the axle rotates you will know you have not pushed the wheels
all the way in. Make sure that the right wheel is attached to the right side and
the left wheel to the left.
4. Tighten the lower folding fixed knob and upper folding fixed knob
4