Table of Contents
Advertisement
KEYPAD FUNCTIONS
Loop range/height
The loop range function selects the degree of arm movement
to achieve maximum motor speed. If a loop range of "0" was
selected the the arm would only have to travel approximately
6° to have the straightener at full speed. If a loop range of "8"
was selected the arm would travel approximately 60° to have
the straightener at full speed. This function is active in the
"RUN" mode.
Loop Range
8
7
Each number
6
is the distance
5
from rest that
4
the dancer has
3
to move to
2
achieve full speed
of the reel motor
The loop height function selects the degree of arm movement
to start roll rotation. If a loop range of "0" was selected
the the arm would only have to travel approximately 6° to
start roll rotation. If a loop range of "8" was selected the
arm would travel approximately 60° before starting roll
rotation.
To set the loop height, thread up the material with the dancer arm
resting on the material. If the straightener is running with the
dancer arm in this position adjust the loop height until straightener
stops. This is your new at rest position. This function is active in
the "RUN" mode.
% Speed setting
The % speed setting allows you to adjust the maximum speed
the rolls will rotate. This should be set to maintain a constant
feed rate. This function is active in the "RUN" mode.
Each number
is the distance
from rest that
the dancer has
to move to
start reel rotation
1
0
AT REST
7
Loop Height
8
7
6
5
4
3
2
1
0
AT REST
Advertisement
Table of Contents
