Table of Contents
Advertisement
JOG SPEED ADJUSTMENT & DANCER ARM
CALIBRATION
Your straightener was shipped with the dancer arm set up for it's
correct position so the only thing that has to be reset would be
the jog speed if you need your unit to jog faster or slower.
To reset the jog speed, turn off the main power switch. Press and
hold the "Run/Stop/Jog" button while turning the main power switch
on. The first screen you will see will display the jog speed percentage.
JOG SPEED
NEXT
To increase the jog speed, press the "Start Speed"
pushbutton. If you want to decrease the jog speed press the
"Start Speed"
%
_
SPEED
The jog speed is shown in the percent of maximum jog speed.
Once you have set the desired jog speed push the "Run/Stop/Jog"
button once for next. Your jog speed is now set.
The next screen asks if you want to set up the sensor (commonly
referred to as "dancer arm calibration"). Use the percent speed
buttons to select "yes" or "no".
Select "no" if all you wanted to do was change the jog speed, select
"yes" if you want to calibrate the dancer arm by resetting the sensor.
SETUP SENSOR
NEXT
If you selected "yes" the next screen asks you to set the low set point.
If the dancer arm is resting on the positive stop then just save this
setting by pushing the "Run/Stop/Jog" button.
SENSOR LOW SETPOINT
SAVE
23% + _
pushbutton.
After making your selection, press
YES
"Run/Stop/Jog" for next.
NO
xxx
8
%
SPEED
+
Advertisement
Table of Contents
