Table of Contents
Advertisement
JOG SPEED ADJUSTMENT & DANCER ARM
CALIBRATION
The next screen is for setting the high set point. Raise the dancer
arm to it's upper stop position and press the "Run/Stop/Jog" button
once to save this setting.
SENSOR HIGH SETPOINT
SAVE
xxx
The next screen is to set the offset of the program. Potentiometers
are hard to get set perfectly so we've built in an offset. After setting
the high & low points, with the dancer arm resting on the positive
stop, put the unit in the "Run" mode. If the unit starts running with
the dancer arm on the positive stop then an offset needs to be put
in. If an offset needs to be put in go through the setup procedure
again until you get to the low offset screen. Using the percent speed
buttons put in an offset value of -3 to -5. Press the "Run/Stop/Jog"
button to save this setting.
LOW OFFSET
+0
NEXT
You now have set the dancer arm limits. The next screen to appear
allows you to exit the setup. Use the percent speed button to enter
"yes or no".
EXIT SETUP
If "yes" was selected press "Run/Stop/Jog" button and the next screen
SHUT OFF POWER TO
SAVE AND EXIT
Power off unit, the dancer arm is now ready for production running.
+
_
YES
NO
appears.
9
Advertisement
Table of Contents
