Battery Indicator; Auto Battery Save - Cobra microTALK FRS 307-2 VP Operating Instructions Manual

O P E R AT I O N
Turning On Your
®
microTALK Radio
1. Press and hold the ON/OFF POWER
button for 2 seconds. A series of audible
tones will indicate the radio is on.
ON-OFF/POWER
b u t t o n
2. Your microTALK ® is now in Standby mode,
ready to receive transmissions. The radio is
always in Standby mode except when the
TALK, CALL, or MODE buttons are pressed.
(For Advanced Features accessed through
the MODE button, see page 7.)
Illuminating the Display
1. Press and release the LIGHT/MAX RANGE
button to illuminate the display for
10 seconds.
LIGHT/MAX RANGE
b u t t o n
3
ENGLISH

Battery Indicator

When only one segment of the battery
indicator is blinking, the battery power is low
and you should recharge
your FA-BP battery pack
or change your AAA
alkaline batteries.

Auto Battery Save

®
Your microTALK radio has a unique circuit
designed to extend battery life. If there are no
transmissions within 10 seconds, the unit will
automatically switch to Battery Save mode
and POWER SAVER will
appear in the display.
This will not affect the
unit's ability to receive
incoming transmissions.
Selecting a Channel
1. With the radio on, select any of the
14 channels by pushing the CHANNEL UP
or CHANNEL DOWN button.
(NOTE: Both radios must be tuned to
the same channel to communicate.)
C H A N N E L CHANNEL
D O W N U P
ENGLISH
Selecting a CTCSS
Privacy Code
CTCSS (Continous Tone Coded Squelch
System) is an advanced tone coding system
allowing you to select one of 38 privacy codes
to reduce interference from other users on the
channel. (NOTE: If you are using a privacy
code, both radios must be tuned to the same
channel and privacy code to communicate.
Each channel will remember the last privacy
code you selected.) To select a privacy code:
1. After selecting a main channel, press and
release the MODE button. A small number
will flash next to the channel in the LCD.
M O D E
b u t t o n
2 . Push the CHANNEL SELECT button up or
down to select a privacy code. You can hold
the button up or down for fast advance.
C H A N N E L
CHANNEL
D O W N
U P
O P E R AT I O N
3. When your desired pri v acy code is displayed,
p ress and release the LOCK button or pre s s
mode to enter selection and go to the next
f u n c t i o n .
LOCK
b u t t o n
Calling Another Person
To alert another person that you are calling:
1 . P ress and release the CALL button. The other
person will hear a 2-second ringing tone.
CALL button
You cannot send or receive transmissions
during the 2-second call tone. (See page
13 for instructions on how to select between
5 call tone settings.)
4