Installation - Thetford Aqua-Magic IV Foot Pedal Flush Owner's Manual

Installation

Refer to diagrams on page 6.
1) Remove old toilet and closet flange seal.
2) Attach new closet flange seal to new toilet (Fig. 1).
3) With mounting bolts in place, position toilet over
closet flange (Fig. 2).
4) If carpeted, trace around toilet, remove toilet and
cut away carpet to expose floor. Carpet beneath
foot pedal may also need to be removed.
5) Using body weight, press toilet to floor.
6a) Aqua Magic IV and Aurora: Tighten nuts 1 to
2 turns past finger tight so toilet is stable.
6b) Aqua Magic Galaxy/Starlite: Finger tighten rear
nut. Prop open flush hole (Fig.3). Finger tighten
front nut (now visible through opening above foot
pedals). Tighten front and rear nuts 1 to 2 turns past
finger tight so toilet is stable (Figs. 4, 5, 6).
7) Check for free blade movement. Loosen nuts as
necessary.
8) Connect water line to water valve/elbow using 1/2"
NPT tube fittings while supporting elbow with wrench.
9) Turn on water and flush. Check for leaks.
10) Flood Test: With toilet water supply turned off, fill
holding tank (using a garden hose) through flush
hole until water level reaches top of bowl. Leave
for 10 minutes with blade open. Check for leakage
around base of toilet.
11) Aurora only: Attach side access covers (Fig. 7).
Removal
Follow the installation directions in reverse order.
4