Removal And Installation Of An Expansion Card - Siemens Simatic 620 Owner's Manual

SIMATIC Box PC 620 Expansions
4.4.2

Removal and Installation of an Expansion Card

Proceed as follows:
1. Open the housing as described in Section 4.1.
2. Remove all connectors from the expansion card and note the assignment.
3. Remove the device for holding down the modules as described in Section 4.4.1.
4. Undo the screw on the slot plate of the module.
5. Pull the module out of the slot.
6. Proceed in the reverse order to install the new expansion card.
Slots for expansion cards
Figure 4-11 Removal/Installation of an Expansion Card
4-16
Device for holding down the modules
SIMATIC Box PC 620 Manual
A5E00131465-01