Chapter 2: Installation; Choosing A Place For The Adsl Router; Connecting The Adsl Router - Siemens ADSL 50 User Manual

SANTIS ADSL 50/500 User Manual

Chapter 2: Installation

Choosing a place for the ADSL Router

1. Place the ADSL Router close to ADSL wall outlet and power outlet for the cable to reach it easily.
2. Avoid placing the device in places where people may walk on the cables. Also keep it away from direct
sunshine or heat sources.
3. Place the device on a flat and stable stand.

Connecting the ADSL Router

Follow the steps below to connect the related devices.
Note:
For ADSL standard, a PSTN Microfilter or an ISDN Splitter is necessary on subscriber's
premise to keep the telephone and ADSL signals separated, giving them the capability to
provide simultaneous Internet access and telephone service on the same line.
1a) Analog (PSTN) installation
If your telephone service is analog (SANTIS ADSL 50), proceed as follows to install your Hardware:
Remove the end of the phone line from your phone connector and plug it into the "LINE" plug of the PSTN
Microfilter. Use another phone line to connect your phone and Microfilter. Plug this phone line into the
"PHONE" plug of the ADSL Microfilter, and plug the other end of the line onto your phone.
Y-Line Filters:
1. Unplug the device's cord from the phone jack.
2. Plug the Y-Line Filter into the phone jack.
3. Plug the phone cord (or other device cord) into the "PHONE" jack of your Y-Line Filter.
4. Plug the ADSL cord into the "ADSL" jack of your Y-Line Filter.
2.
10
3.
4.