ALDI Workzone Titanium+ 85509 Instruction Manual page 9

700W AIRLESS SPRAY STATION
9.3 Priming the pump (Fig. 6-9)
a) Submerge the suction tube in the paint inside the paint container.
b) Place the return tube into a waste container.
c) Turn the Prime/Spray knob to PRIME position.
d) Turn the Pressure Control Dial to maximum pressure setting.
e) Turn on the airless spray station. The airless spray station will draw paint
up the suction tube and out of the return tube. Continue until the paint is
flowing out of the return tube into the waste container.
f) Turn off the airless spray station and put the return tube into the paint
container. Bind the suction tube and return tube together with the plastic
clip.
Fig.6
9.4 Priming and purging the spray hose
WARNING! Ensure the spray tip is removed before priming and
purging the spray hose.
DANGER! Keep hands clear from the fluid stream. If using oil-based
paint and material, always ground the spray gun by holding it against
the edge of a metal container while priming and purging. Failure to do
so may lead to static electric discharge, which may cause a fire.
DANGER! If Prime/Spray knob is still in SPRAY position, there will
be high pressure in the spray hose and spray gun until the Prime/Spray
knob is turned to the PRIME position.
01904 727506
GB
16
01247 5150
IRE
Fig.7 Fig. 8 Fig. 9
support@coreservice.co.uk
Operation Operation
a) Turn the Prime/Spray knob to the PRIME position.
b) Aim the spray gun into a waste container. Pull and hold the trigger.
c) Whilst pulling the trigger, turn on the airless spray station and turn the
Prime/Spray knob to SPRAY position.
d) Hold the trigger until all air, water or solvent is purged from the spray
hose and material/paint is flowing freely.
e) Release the trigger, turn the Prime/Spray knob to the PRIME position and
turn off the airless spray station. Aim the spray gun into a waste container,
then pull and hold the trigger to ensure that no pressure is left in the
spray hose.
9.5 Attaching the spray tip guard and spray tip (Fig.10)
WARNING! Do not spray without the spray tip guard and spray tip.
a) Lock the spray gun trigger.
b) Turn the retaining nut of the spray tip
guard onto the pistol of the spray gun
c) Tighten the retaining nut by hand.
d) Insert the spray tip all the way into the
spray tip guard.
support@coreservice.co.uk
700W AIRLESS SPRAY STATION
Fig.10
01904 727506 17
GB
01247 5150
IRE