ALDI Workzone Titanium+ 85509 Instruction Manual page 10

700W AIRLESS SPRAY STATION
9.6 Spraying (Fig. 11)
WARNING! Ensure the spray hose is free of kinks and clear of objects
with sharp cutting edges.
a) Press the ON/OFF switch to turn on the pump of the airless spray station.
b) Turn the Pressure Control Dial anti-clockwise to the lowest setting.
c) Turn the Prime/Spray knob to SPRAY position.
d) Turn the Pressure Control Dial clockwise
to the highest setting.
e) When the motor shuts off, unlock and
pull the trigger to spray a test area and
check the spray pattern.
Note: When there is enough pressure in
the airless spray station, the motor will
shut off automatically. It will cycle on
and off automatically depending on the
pressure inside the airless spray station.
f) Adjust the pressure setting to obtain a
good spray pattern as desired.
9.7 Turning off
a) Release the trigger to stop spraying.
b) Turn the Prime/Spray knob to the PRIME position.
c) Press the ON/OFF switch to turn off the airless spray station.
d) Aim the spray gun into a waste container, then pull and hold the trigger to
ensure no pressure is left in the spray hose.
e) Unplug the airless spray station.
01904 727506
GB
18
01247 5150
IRE
Operation Operation
9.8 Spray technique(Fig.12-14)
a) Keep your arm moving at a constant speed and keep the spray gun at a
b) Keep the spray gun at a right angle to the surface being sprayed.
c) The spray gun should be moving when the trigger is pulled or released.
d) Overlap each stroke by about 30% to ensure an even coating.
Fig.11
support@coreservice.co.uk
constant distance from the surface being sprayed. The best distance is
25cm to 30cm.
Fig.12 Fig.13
support@coreservice.co.uk
700W AIRLESS SPRAY STATION
Fig.14
01904 727506
GB
19
01247 5150
IRE