Material And Paint Selection - ALDI Workzone Titanium+ 85509 Instruction Manual

700W AIRLESS SPRAY STATION
h) Plastics can cause static sparks. Never hang plastic sheets to enclose
the spray area. Do not use plas c drop cloths when spraying flammable
materials.
i) Always read the paint manufacturer's thinning instructions before
use .
j) Always keep the spray nozzle in place during use. Never allow the spray
to come in direct contact with the skin.
k) Always disconnect from mains supply when refilling the paint container.
l) Switch off when not spraying. Avoid running the airless spray st
there is no paint inside the paint container.
m) Never use the airless spray station outside when it is raining.
n) Switch off immediately if there is an interrup
o) Do not use materials containing bleach or chlorine.
p) Do not use halogenated hydrocarbon solvents such as bleach,
mildewcide, methylene chloride and trichloroethane.
q) Paints, solvents, insecticides and other materials can be harmful if
inhaled or come in contact with the body. Vapours can cause severe
nausea, fain r poisoning.
r) Do not spray outdoors on a windy day.
s) If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
01904 727506
GB
12
01247 5150
IRE
Safety Instructions For Airless Spray Station
n
the mains or smoke.
support@coreservice.co.uk

Material And Paint Selection

7. MATERIAL AND PAINT SELECTION
WARNING! Do not use textured wall paints or coatings as this will
block the spray gun tip and damage internal components of the airless
spray station.
7.1 Material and paints which can be used:
The following materials and paints can be used. Although a large number
of materials and paints can be sprayed, some cannot. Please check with the
manufacturers' recommendations.
• Water based paints
• Oil based paints
• Enamel paint
• Varnish
• Stains
7.2 Materials and paints which cannot be used:
The use the following materials and paints will cause premature wear and
block the spray tip. This will void warranty.
a) Paints and lacquers containing heavily abrasive components such as
• Exterior textured wall paints
• Glazes
• Lyes
• Acids
b) Silicate paints
c) Flammable materials
support@coreservice.co.uk
700W AIRLESS SPRAY STATION
• Wood preservatives
• Primers
• Wash primer
• Oil
• Dispersion paints
• Caustic and alkaline substances
• Textured coating
• Emulsion paints
01904 727506
GB
01247 5150
IRE
13