ALDI Workzone Titanium+ 85509 Instruction Manual page 15

700W AIRLESS SPRAY STATION
Does not draw in paint The airless spray station is not
when the Prime/Spray primed p r roperly
knob is set to PRIME
The suction tube is not
position
immersed in the paint
The suction tube is clogged
The suction tube is not
connected to the suction tube
inlet port properly
The valve of the Prime/Spray
knob is faulty
Draws up paint but the The spray tip is worn
pressure drops when
spraying
The suction tube filter is
clogged
The spray gun filter is clogged
The paint is too thick
The Prime/Spray knob The Prime/Spray knob is dirty
is in the SPRAY position, and worn
but the paint flows
through the return tube
The spray gun leaks The spray tip is not assembled
properly
A seal is dirty
The spray gun will not The spray tip or the spray gun
spray filter is blocked
The spray tip is in the reverse
position
The paint pattern is The Pressure Control Dial is set
tailing too low
The spray gun filter, spray tip
or the suction tube filter is
clogged
The connection of the suction
tube is loose at the Suction
Tube Inlet Port
The spray tip is worn
The paint is too thick
01904 727506
GB
28
01247 5150
IRE
Technical Specifications
Prime the airless spray station
Immerse the suction tube in the
paint
Clean the suction tube and
suction tube filter
Check the connection and
tighten the connection
Repair by an authorised service
centre
Replace the spray tip with a new
one
Clean the suction tube filter
Clean the spray gun filter
Thin the paint according to the
manufacturer's instructions
Repair by an authorised service
centre
Check the spray tip assembly
Clean the seal
Clean the spray tip and the spray
tube filter. Ensure the spray tube
filter is seated properly
Check and turn the spray tip in
the forward position
Turn the Pressure Control Dial to
a higher setting
Clean the spray gun filter, spray
tip or the suction tube filter
Tighten the connection
Replace the spray tip
Thin the paint according to the
manufacturer's instructions
support@coreservice.co.uk
Residual Risks
16. TECHNICAL SPECIFICATIONS
Model No.
Rated voltage
Rated wattage
Maximum flow rate
Maximium spray pressure
Weight
Hose length
Sound pressure
Noise information
WARNING!
Health hazard!
Working without ear protection and suitable protective clothing poses a health
hazard.
− Wear ear protection and suitable protective clothing when working with
the device.
Measured in accordance with DIN EN 60745. The noise at your workplace may
exceed 85 dB(A); protective measures are necessary in this case (wear suitable ear
protection).
• Sound pressure level :
• Uncertainty K:
The aforementioned values are noise emission values and therefore, do not
necessarily represent safe values for the workplace. The correlation between
emission and imission levels cannot reliably provide for a conclusion as to whether
additional cautionary measures are necessary or not.
Factors that could affect the respective imission level present at the workplace involve
the specification of the work area, the surrounding area, the duration of exposure,
other noise sources etc.
support@coreservice.co.uk
700W AIRLESS SPRAY STATION
PLD3090
220-240V~ 50Hz
700W
1100ml/min
3000psi
8.7kg
7.5m
95.4 dB(A); uncertainty K = 3 dB(A)
95.4 dB(A)
3 dB(A)
01904 727506
GB
01247 5150
IRE
29