Gigaset 11 User Manual page 11

Installing the Gigaset USB Adapter 11
6. After the software installation is finished, plug the Gigaset USB Adapter 11 into the
USB port of your computer.
i
7. Upon hardware detection, Windows OS will install the driver for the card automati-
cally.
Note:
If you are prompted with the "INF not found" alarm, please click the Browse button
◆
to locate the .inf file. Usually it is located on C:\Windows\inf or C:\Winnt\inf.
For Windows 2000: If you are prompted with the Digital Signature not Found alarm
◆
message, just click Yes to ignore it and continue with the auto-installation.
For Windows 98 SE: If prompted, you need to insert your Windows 98 SE installation
◆
CD to complete the driver installation.
If you need to set up the TCP/IP address or the subnet mask, refer to "Set-
i
ting up TCP/IP" on page 39 for details.
Now you are done with the installation procedure. If the Wireless LAN Monitor Utility
does not start automatically, select Start - Programs - Wireless LAN Client Utility -
Wireless LAN Monitor Utility. You should be able to see the Wireless LAN Monitor
icon appearing on the right side of the taskbar. Proceed to following chapter to config-
ure or fine-tune your Gigaset USB Adapter 11 settings.
10
The red LED on the Gigaset USB Adapter 11 will light when the Gigaset
USB Adapter 11 is connected to your computer.