Advertisement
Sleep mode
： ： ： ：
I n this mode the fan speed will continuously vary speed to assist in keeping
cool at night when asleep. You can select 3 different running patterns in this mode by using
the Speed Selection button, the patterns of operation in each speed mode are as follows;
- High speed: Varies between High speed in Normal Blower mode→ Medium speed in
Natural Blower mode→ Low speed in Natural Blower mode:
- Medium speed: Varies between Medium speed in Natural Blower mode →Low speed in
Natural Blower mode
- Low speed
O perates at Low speed in Natural Blower mode.
：
3).Runback Timer Mode Button-
continuously in your selected mode of operation for different time intervals, you can select 1
hour, 2 hours, 4 hours or 8 hours, the selected period will be indicated by its LED light which
will remain on for the selected period, when the selected operating time has run out the
product will switch off automatically and go into standby mode until the user needs it again.
4) Fan Speed Selection Button -
operate in Normal mode at Low speed with the low speed LED and the power on LED
illuminated. Pressing the
button allows you to change from Low to Medium, Medium to
High and High back to Low fan speed , the relevant LED light will illuminate to indicate which
fan speed is selected/operating.
5) Oscillating Mode Selection Button-
operating you can select between different angles of oscillation for the product. The product
can be set to oscillate at an angle of 30°
indicated by the illumination of the relevant LED. You have to move through all the oscillation
selection options to return to oscillation off mode (when no oscillation LED will be lit).
Note that the oscillation is controlled by what's called a stepping motor, this means it will
swing first to the right and then to the left from the starting point over half the swing angle
selected, this applies to all angles apart from the 360º selection, in this setting it will swing
clockwise continuously around completing 360º each time it rotates
: By pressing this button, the fan can be set to operate
W hen you start the product it will always default to
：
: By pressing this button while the product is
9 0°
1 80° or 360°, the angle selected will be
，
，
7
6) Please Note
In any mode of operation you can use the power button to switch the product off/into standby
mode at any time, when you next press the power button to switch the product back on it will
remember the last wind speed and oscillation settings and switch back on at these in Normal
Blower Mode, it will not remember if the product was in a Runback Timer mode or in a
different Blower Mode setting.
NB - If the fan speed varies randomly automatically you have selected NATURAL
mode which simulates natural breeze conditions. THIS IS NOT A FAULT. To de-select
this operation please press the MODE button
symbol
is lit and only use the SPEED selection button
the fan speed you require (Low / Med / High).
NB – When the product is left running without switch/control operation for 1 minute the LED
indicator light display will switch off automatically, this is to avoid user disturbance or
distraction by the light (particularly if used at night), The lights will switch on again when the
user activates any control button (except the off button), the product can then be operated
normally as described above, if the 'off' button is activated the product will just switch off and
the lights will not re-energise.
7) Remote Control Use:
- To activate the remote control release and slide out the battery holder from the bottom back
of the remote control handset (as indicated below), install your 3V CR2032 button battery
cell into its location ensuring the positive and negative pole are as indicated on the label on
the back of the remote and reinstall the battery holder completely. Align to infrared receiver
module when using remote controller.
- Remote Control will only operate the product if it is in direct line of site and within a distance
of 6 meters from the product. If it fails to do so under these conditions after the product has
been in use for some time please check the battery is not depleted before taking any other
action.
until a NORMAL mode speed
to change and select
8
Advertisement
