Timer Operation - Toshiba MCY-MHP0404HS Owner's Manual

2FAN_OM_DB11206501-00.book Page 8 Thursday, March 3, 2016 5:44 PM
Changing the fan speed
1
Push the "FAN " button to select a fan
speed.
• Each time you push the button, fan speed and its
indication change in the following order:
(" Auto" cannot be selected in the FAN
mode.)
Auto High Medium Low
• When heating, if the room does not heat up using
" Low", select " High" or " Medium".
• The temperature sensor detects the return air
temperature at the indoor unit, which may slightly
differ from the actual room temperature
depending on installation condition. Set
temperature is a target of room temperature.
EN-15
Changing the set Temperature
1
Push the "TEMP. " buttons.
Push to increase the temperature, and to
decrease the temperature. (The set temperature
cannot be changed in the fan mode.)
NOTE
When cooling
Running starts in approximately 1 minute.
When heating
• The air conditioner may continue running in the fan
mode for about 30 seconds after stopping heating.
• The heated air comes out after a 3 to 5 minutes of pre-
heating with the indoor fan kept turned off. (The pre-
heat indicator is displayed on the remote
controller.)
• The fan speed becomes extremely low when the room
temperature has reached the set temperature.
– 8 –
5

Timer Operation

Select a timer type from the following three: (Max. 168 hours)
OFF timer : Stops running after the specified period.
Repeat-OFF timer : Stops running after the specified period every time you use the air conditioner.
On timer : Starts running after the specified period.
Setting the timer
1
3
1
Push the button.
Each time you push the button, the timer mode and
indication change in the following order:
On
Off Off
(Off timer) (Repeat Off timer) (On timer)
No indication (Timer
function is deactivated)
• and the time indicator blink.
2
Push the buttons to set the period of time
until the timer actions.
• The time setting increases in 0.5-hour (30-minute)
increments each time you push .
The setting increases in 1-hour increments if it is
over 1d (24 hours). The maximum is 7d (168
hours).
On the remote controller, settings between 0.5h
and 23.5h (*1) are displayed as is.
If it is over 24 hours (*2), the days and hours
appear.
• The time setting decreases in 0.5-hour (30-
minute) decrements (0.5 hours to 23.5 hours) or
1-hour decrements (24 hours to 168 hours) each
time you push .
Example of remote controller display
• 23.5 hours (*1)
Owner's Manual
2
• 34 hours (*2)
indicates 1 day
(24 hours).
Days Hours
indicates 10 hours.
(Total: 34 hours)
3
Push the button.
disappears, the time indication is displayed,
and or display flashes.
(When using the ON timer, all indications other than
the time and turn off.)
Cancelling the timer
1
Push the button.
The timer indicator disappears.
NOTE
• When using Repeat OFF timer, pushing the
button after stopping by the timer starts running again
and the timer will stop the running again after the
specified period.
• When using OFF timer, the timer indication temporarily
disappears for about 5 seconds by pushing the SWING/FIX
button. This occurs due to the processing in the
remote controller, and is not a malfunction.
EN-16