Work Safety Information - Siemens CMTC1720 User Manual

Work Safety Information

2 Work Safety Information
6
Siemens Building Technologies
Fire Safety & Security Products
Do not modify the monitor power plug in any way.
1.
Operate this unit only from the type of power source indicated on the label.
2.
Do not block or cover ventilation openings on the back or bottom of the
3.
monitor cabinet.
Do not place this monitor near a radiator or heating vent.
4.
Do not push objects of any kind through cabinet openings. This may result in
5.
fire or electrical shock.
Before adding attachments always ask a service technician to perform routine
6.
safety tests to determine that equipment is in safe operating condition.
Ground potential tests should be part of the routine safety check made by the
service technician.
Do not place monitor on an unstable cart, stand, or shelf where it may fall and
7.
injure personnel or damage equipment.
Route power cords so that they cannot be walked upon or tripped over. Do
8.
not allow anything to rest on the power cord.
Do not install monitor in wet areas, or where it may be exposed to rain or
9.
water. Do not spill liquid of any kind on the unit.
10. Unplug the power cord from the unit before cleaning the display. Use only a
damp cloth. Do not use alcohol, spirits, or ammonia to clean the display.
Do not attempt to clean the interior of this unit – this action must be performed
by the service technician as required during normal maintenance.
11. Refer all servicing to qualified service personnel. Removal of back cover by
unauthorized personnel may expose the user to dangerous voltages or other
hazards.
12. Unplug the unit immediately and notify the service technician.
If liquid has been spilled into the display or the display has been exposed to
–
rain or water.
If the unit has been dropped or the cabinet damaged.
–
If fuses continue to blow.
–
If the power cord is damaged or frayed.
–
If a distinct change from normal operation is apparent.
–
When replacement parts are required, be sure that the service technician uses
components specified by the manufacturer which have the same characteristics as
the original parts. Unauthorized substitutions may result in fire, electrical shock or
other hazards.
Upon completion of any service or repairs, ask the technician to perform safety
checks to determine that the equipment is in safe operating condition.
Serious shock hazards exist within the covers of this monitor. Do not open the
covers under any circumstances, there are no user serviceable components
WARNING
inside.
10.2006