Siemens Gigaset SL370 Owner's Manual page 9

First steps
Please note:
To remove the battery pack, you must first
press the bracket on the side.
Closing the battery cover
¤
Align the battery cover parallel to the
casing and press down until it clicks
into place.
Attaching the belt clip
There are notches for attaching the belt
clip on the side of the handset at the same
height as the display.
¤
Press the belt clip onto the back of the
handset so that the protrusions on the
belt clip engage with the notches.
8
Opening the battery cover
¤
If fitted, remove the belt clip.
¤
Lift the device with the keypad facing
the palm of your hand.
¤
Place the thumb of your other hand on
the loudspeaker (a) and use the index
finger of the same hand to press the
groove at the top of the handset (b).
¤
Lift the cover.
Placing the handset in the charging
cradle
¤
Plug the charging cradle mains adapter
into a mains power socket.
¤
Place the handset in the charging cra-
dle with the display facing forward.
The handset is already registered with the
base station at the factory.
the display. You do not have to re-register.
If, nonetheless, you have to register your
handset with the base station, see
page 43.
Please note:
You can change the name of the handset
(page 45).
To charge the battery pack, leave the
handset in the charging cradle.
Please note:
– If the handset has switched itself off
because the battery pack is flat and is then
placed in the charging cradle, it will switch
itself on automatically.
– Only place the handset in the charging cra-
dle that is intended for it.
For questions and problems see page 61.
a
b
INT 1 appears in