Charge Battery - Siemens S55 Manual

10

Charge battery

The battery is not fully charged
when delivered. Plug charger cable
into the bottom of the phone, plug
power supply unit into a power sock-
et and charge for at least two hours.
Display when charging is in progress
h
During charging.
Charging time
An empty battery is fully charged
after about 2 hours. Charging is only
possible in an ambient temperature
of 41 °F to 104 °F (the charge icon
flashes as a warning when the tem-
perature is 41 °F above/below this
range). The voltage specified on the
power supply unit must not be ex-
ceeded.
To obtain maximum performance
from the battery, it must be fully
charged and then emptied at least
five times.
Note
Your phone's display is delivered with a protective film.
Remove this film before getting started.
In rare cases, the static discharge may cause discoloration at the edges of the display. How-
ever this will disappear within 10 minutes.
Getting started
Charge icon not visible
If the battery is totally discharged, no
charge icon is displayed when the
charger is plugged in. It will appear
after two hours at most. In this case
the battery is fully charged after
3-4 hours.
Only use the charger provided!
Display while in service
Charge level display during opera-
tion (empty-full):
A beep sounds when the battery is
nearly empty. The battery level is
only shown correctly during an un-
broken charging/discharging cycle.
You should therefore not remove the
battery unnecessarily and where possi-
ble not finish the loading process early.
a d g
Note
The charger heats up when used for long
periods. This is normal and not dangerous.
Performance...............................page 118
Battery quality statement............page 114