Young 32400 SERIAL INTERFACE Instructions Manual page 4

SERIAL COMMANDS TABLE
Command
CMD100 OPERATE
CMD110 PAUSE
CMD200 n DAMPING (0=NONE, 1=FAST, 2=SLOW)
CMD210 n FORMAT:
0 ASCII
1 POLLED ASCII
2 NMEA (KTS, DIR)
3 NMEA (KTS, DIR, TEMP, RH, BARO)
4 RMYT
5 PRECIP
6 PRECIP POLLED
7 ASCII 2
9 DIAGNOSTIC
CMD220 n OUTPUT RATE (0=15Hz, 1=0.1Hz, 2=2Hz)
CMD230 c POLL CHARACTER (0-9, A-Z)
CMD240 nn BAUD RATE:
12 = 1200, 48 = 4800, 96 = 9600,
192 = 19200, 384 = 38400
CMD250 n INPUT TYPE (1 = PULSE/POT, 2 = VIN3/VIN4)
CMD260 nnnn BARO RANGE LOW (hPa)
CMD270 nnnn BARO RANGE HIGH (hPa)
CMD280 nnn PROPELLER PITCH (mm/rev)
CMD900 REPORT PARAMETER SETTINGS
CMD910 START COMPASS CALIBRATION
CMD920 STOP COMPASS CALIBRATION
X Alternative command to enter OPERATE mode
3xESC Alternative command to PAUSE
3xCNTL-S Alternative command to START calibration
3xCNTL-X Alternative command to STOP calibration
Description
Page 3
Notes:
Places unit in continuous or polled operation
Interrupts/pauses operation
Determines compass measurement averaging (32500 Only)
Determines serial output format.
See section 3.1 for more detailed information.
PRECIP formats substitute tipping bucket precipitation counts for
the VIN4 voltage measurement.
ASCII 2 omits VIN measurement values from the output string
The rate at which serial data strings are sent.
Sets the unique, single alphanumeric character polling address
Selects one of several preset baud rates. If you change baud rate
while connected, your external device must also be changed in
order to continue communicating with the 32400
Determines wind speed & direction inputs to use for output
calculation. Type 2 requires 0 to 5000 mV = 0 to 100 m/s (VIN1)
and 0 to 540 degrees (VIN2). Type 2 typically used for 86000 family
of 2D Ultrasonic Anemometers.
Sets barometer low range at 0.0VDC (0500 hPa default)
Sets barometer high range at 5.0VDC (1100 hPa default)
Sets sensor cup wheel/propeller pitch
03002: 750 mm/rev
04101/4106/05103/05106: 294 mm/rev (default)
05108: 500 mm/rev
05305: 307 mm/rev
Returns list of current settings in unit
See section 3.1 (32500 only)
See section 3.1 (32500 only)
Places unit in continuous or polled operation
Interrupts/pauses operation
See section 3.1 (32500 only)
See section 3.1 (32500 only)
32400-90(R)