Getting Started; Turning Reader On And Off - Biomark HPR Lite User Manual

2 Getting Started

2.1 Turning Reader On and Off

The reader can be powered on by any of the following methods:
•
Pressing and holding the OK button for 1 second.
•
Connecting the reader to the included AC power supply or USB port of a PC.
Upon powering up, the reader will display a splash screen and emit a short beep. This screen will display the
present firmware version in the bottom right corner. After approximately 1.5 seconds, the reader will display
the main screen.
Screen during power up
NOTE: Operating ambient temperature of the HPR Lite reader must be between -20°C (-4°F) and +58°C
(+136.4°F) with relative humidity between 10% and 90%, non-condensing.
The reader can be powered off by any of the following methods:
•
Pressing and holding the OK button while in main screen. After approximately one second a
shutdown timer will appear. Continue holding the OK button until the reader sounds two beeps and
shuts down. The count down can be aborted by releasing the OK button.
•
The reader will automatically power off after certain period of inactivity. The inactivity time is user
adjustable and by default is set to 180 seconds (3 minutes). Pressing any button will reset the
timer.
V1.01.00 V1.01.00
09/27/2017 09/27/2017
READY READY
SHUTDOWN... SHUTDOWN...
3 3
Press and hold READ to Press and hold READ to
scan scan
MEMORY MEMORY
00000 00000
www.biomark.com
7:13 PM 7:13 PM
09/27/2017 09/27/2017
READY READY
Press and hold READ to Press and hold READ to
scan scan
MEMORY MEMORY
00000 00000
Main Screen
7:13 PM 7:13 PM