Advertisement
Contents of Packaging -
Positioning – Operating Conditions
4
PHONO 2
Italian Prestige phono stage
Volume Control
It is possible vary the PHONO 2 Gain from MM to MC. It is also possible vary the load impedance on this unit.
To do that, it is necessary to carefully unscrew and pull out (remember that the back panel is connected with soldered cables)
the back panel of Phono 1, after switching off the unit it is been disconnected the AC power chord from the wall plug.
Internally on the red schematic board of PHONO 2, underneath two black transformers, there is a small DIP SWITCH with 4
Micro-Switches.
The Micro-Switches 1 & 4 are able to vary the Gain of the unit: with the Micro-Switches towards the NUMBERS SIDE the
PHONO 2 operates in MM mode; with Micro-Switches towards the ON SIDE the PHONO 2 operates in MC mode.
The Micro-Switches 2 & 3 are able to vary the load impedance of the unit: with the Micro-Switches towards the NUMBERS
SIDE the PHONO 2 operates with a fix 47Kohm (right for all MM cartridges); with Micro-Switches towards the ON SIDE the
PHONO 2 operates with a 470ohm (default) or changing the resistors (optional) with the unit with a specific load as requested
by the user.
Hide quick links:
Advertisement
